2003 Mazda Protege5 Air Intake Kit Parts

Choose your Engine for your 2003 Mazda Protege5

4 Cyl 2.0L

Showing 1 - 3 of 3 products

Sort:

Show:

Image

SKU

Product

Rating

Price

2003 Mazda Protege5 Air Intake Kit K&N

Round; Red Cotton Gauze Air Filter; Natural Stainless Steel Clamp; Estimated Horse Power Gain 5 HP At 3568 RPM;CARB E.O. D-269-24
K/N s easy-to-install Typhoon cold-air intake system replaces the restrictive factory air filter and air intake housing delivering a guaranteed power gain. The low-restriction aluminum intake tubes come in a red powder coat finish.
Performance Air Intake System
Product Attributes:
- WARNING CA Proposition 65: Yes
- Prop 65 Warning Label: Https://www.knfilters.com/images/l/prop65.jpg
- WARNING CA Proposition 65 Message: Warning: Cancer And Reproductive Harm - Www.p65warnings.ca.gov
- Prop 65 (C, R or CR): Cr
Features:
- Performance Air Intake System
The KN 69-6020TR Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Mazda Protege, Protege5 and MP3 models. The restrictive factory air filter and air intake housing are replaced by the KN Typhoon cold-air intake which is designed to pull in outside air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range. The 69-6020TR cold-air intake consists of a black rubber topped KN high-flow air filter that mounts near the driver side wheel well directing outside air through free-flowing aluminum tubing into a short ram induction tube that delivers high volumes of clean air into the engine's throttle body for a guaranteed power gain. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the vehicle applications and specific CARB status for each vehicle and air intake.

Additional Fitment Information:

Vehicle
2003 - Mazda Protege5

Brand	K&N
Part #	69-6020TR
Condition	New
Warehouse	C

2003 Mazda Protege5 Air Intake Kit 4 Cyl 2.0L K&N

Performance Air Intake System
Includes Red Air Filter/Red Tubing; Estimated Horsepower Gain 5 HP At 3568 RPM; 1/4-20 Jack Nut Into Top;CARB E.O. D-269-24 1/4-20 Jack Nut Into Top
K/N s easy-to-install Typhoon cold-air intake system replaces the restrictive factory air filter and air intake housing delivering a guaranteed power gain. The low-restriction aluminum intake tubes come in a red powder coat finish.
Typhoon Complete Cold Air Induction Kit
Product Attributes:
- Oil Included: Filter Is Pre-oiled
- Air Filter Height: 5.500 In. (140mm)
- Coupler Color: Black
- Estimated Horse Power Gain: 5 Hp @ 3568 Rpm
- TUV Approved (Europe): No
- Intake Pipe Inlet Shape: Round
- Replacement Filter: Ru-4950
- Item Weight: 9.300 Lbs. (4.2 Kg)
- System Type: Complete Cold Air
- Clamp Quantity: 9
- Intake Pipe Outlet Shape: Round
- Intake Pipe Color: Red
- Mass Air Flow Sensor Included: Mass Air Flow Sensor Adapter Included When Required
- Prop 65 (C, R or CR): Cr
- WARNING CA Proposition 65 Message: Warning: Cancer And Reproductive Harm - Www.p65warnings.ca.gov
- Flange Angle: 0 Degree
- Horse Power Increase: 5 Hp
- Air Filter Element Washable: Yes
- Flange Inside Diameter: 2.500 In. (64mm)
- Prop 65 Warning Label: Https://www.knfilters.com/images/l/prop65.jpg
- Flange Type: Centered
- Intake Pipe Outlet Width: 2.500 In. (64mm)
- Flange Length: 2.000 In. (51mm)
- Flange Offset: 0.000 In. (0mm)
- Clamp Style: Regular
- Mounting Hardware Included: Yes
- WARNING CA Proposition 65: Yes
- Base Outside Diameter: 6.000 In. (152mm)
- RPM: 3568
- Filter Material: Cotton Gauze
- Air Filter Outlet Shape: Round
- Air Filter Outlet Length: 2.500 In. (64mm)
- Air Filter Large End Diameter: 6.000 In. (152mm)
- Clamp Color: Natural
- Item Height: 5.500 In. (140mm)
- Clamp Material: Stainless Steel
- Top Style: X-stream
- Top Material: None
- Intake Pipe Material: Aluminum
- Air Filter Outlet Width: 2.500 In. (64mm)
- Intake Pipe Inlet Length: 8.000 In. (203mm)
- Top Outside Diameter: 5.000 In. (127mm)
- Couplers Included: 4
- Package Material: Paperboard
- Intake Pipe Inlet Width: 2.500 In. (64mm)
- Intake Pipe Outlet Length: 20.000 In. (508mm)
- Filter Color: Red
- Package Type: Box
- Air Box Included: No
- Street Legal: Yes
Features:
- Performance Air Intake System
The KN 69-6020TR Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Mazda Protege, Protege5 and MP3 models. The restrictive factory air filter and air intake housing are replaced by the KN Typhoon cold-air intake which is designed to pull in outside air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range. The 69-6020TR cold-air intake consists of a black rubber topped KN high-flow air filter that mounts near the driver side wheel well directing outside air through free-flowing aluminum tubing into a short ram induction tube that delivers high volumes of clean air into the engine's throttle body for a guaranteed power gain. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the vehicle applications and specific CARB status for each vehicle and air intake.

Additional Fitment Information:

Vehicle	Block	CC	Engine	CID
2003 - Mazda Protege5	L	2000	4 Cyl 2.0L	-

Brand	K&N
Part #	69-6020TR
Condition	New
Warehouse	C

2003 Mazda Protege5 Air Intake Kit 4 Cyl 2.0L K&N

Performance Air Intake System
Includes Red Air Filter/Silver Tubing; Estimated Horsepower Gain 5 HP At 3568 RPM; 1/4-20 Jack Nut Into Top;CARB E.O. D-269-24 1/4-20 Jack Nut Into Top
K/N s easy-to-install Typhoon cold-air intake system replaces the restrictive factory air filter and air intake housing delivering a guaranteed power gain. The low-restriction aluminum intake tubes come in a silver powder coat finish.
Typhoon Complete Cold Air Induction Kit
Product Attributes:
- Oil Included: Filter Is Pre-oiled
- Air Filter Height: 5.500 In. (140mm)
- Coupler Color: Black
- Estimated Horse Power Gain: 5 Hp @ 3568 Rpm
- TUV Approved (Europe): No
- Intake Pipe Inlet Shape: Round
- Replacement Filter: Ru-4950
- Item Weight: 9.300 Lbs. (4.2 Kg)
- System Type: Complete Cold Air
- Clamp Quantity: 9
- Intake Pipe Outlet Shape: Round
- Intake Pipe Color: Silver
- Mass Air Flow Sensor Included: Mass Air Flow Sensor Adapter Included When Required
- Prop 65 (C, R or CR): Cr
- WARNING CA Proposition 65 Message: Warning: Cancer And Reproductive Harm - Www.p65warnings.ca.gov
- Flange Angle: 0 Degree
- Horse Power Increase: 5 Hp
- Air Filter Element Washable: Yes
- Flange Inside Diameter: 2.500 In. (64mm)
- Prop 65 Warning Label: Https://www.knfilters.com/images/l/prop65.jpg
- Flange Type: Centered
- Intake Pipe Outlet Width: 2.500 In. (64mm)
- Flange Length: 2.000 In. (51mm)
- Flange Offset: 0.000 In. (0mm)
- Clamp Style: Regular
- Mounting Hardware Included: Yes
- WARNING CA Proposition 65: Yes
- Base Outside Diameter: 6.000 In. (152mm)
- RPM: 3568
- Filter Material: Cotton Gauze
- Air Filter Outlet Shape: Round
- Air Filter Outlet Length: 2.500 In. (64mm)
- Air Filter Large End Diameter: 6.000 In. (152mm)
- Clamp Color: Natural
- Item Height: 5.500 In. (140mm)
- Clamp Material: Stainless Steel
- Top Style: X-stream
- Top Material: None
- Intake Pipe Material: Aluminum
- Air Filter Outlet Width: 2.500 In. (64mm)
- Intake Pipe Inlet Length: 8.000 In. (203mm)
- Top Outside Diameter: 5.500 In. (140mm)
- Couplers Included: 4
- Package Material: Paperboard
- Intake Pipe Inlet Width: 2.500 In. (64mm)
- Intake Pipe Outlet Length: 20.000 In. (508mm)
- Filter Color: Red
- Package Type: Box
- Air Box Included: No
- Street Legal: Yes
Features:
- Guaranteed To Increase Horsepower
- Designed To Improve Throttle Response And Engine Sound
- Free Flowing Aluminum Tube
- Easy To Install Usually In 90 Minutes or Less
- Lasts Up To 100000 Miles Before Service Is Required
- Replaces Entire Factory Air Intake System
- Washable And Reusable Lifetime Air Filter
- K&N Million Mile Limited Warranty
The K&N 69-6020TS Typhoon cold-air intake system is a free-flowing, mandrel-bent aluminum tube air induction system designed to fit some Mazda Protege, Protege5 and MP3 models. The restrictive factory air filter and air intake housing are replaced by the K&N Typhoon cold-air intake which is designed to pull in outside air and dramatically reduce air flow restriction by smoothing and straightening air flow. This allows your engine to inhale a larger amount of air than the factory air intake. More air means more usable power and acceleration throughout the engine's RPM range. The 69-6020TS cold-air intake consists of a black rubber topped K&N high-flow air filter that mounts near the driver side wheel well directing outside air through free-flowing aluminum tubing into a short ram induction tube that delivers high volumes of clean air into the engine's throttle body for a guaranteed power gain. The oversized cone shaped air filter comes with a water repellent DryCharger filter wrap to protect the filter from moisture. The air filter can be used for up to 100,000 miles before servicing is needed depending on driving conditions. This cold air intake is relatively easy to install usually in 90 minutes or less. Some Typhoon air intakes are not legal for sale or use in California and other states adopting California emission standards while others are CARB exempt and 50 state legal. Check the vehicle applications and specific CARB status for each vehicle and air intake.